I. PRODUCT AND COMPANY IDENTIFICATION

Product Name:	AMERIGUARD IRRIGATION DRIP OIL
Product Code:	AG-DRIP-XX
Emergency Phone:	(800) 424-9300         (202) 483-7616         (CHEMTREC)
Poison Control Center:	(800) 222-1222
Company:	SBP, Inc. 9915 SO. 148 ST. Omaha, Ne 68138
Information Phone:	(800) 233-4059          (402) 895-2202
Revision Number:	2

II. COMPOSITION/INFORMATION ON INGREDIENTS

Chemical Name	%	CAS #	OSHA Exposure Limits
Distillates (petroleum), solvent-dewaxed heavy paraffinic Heavy hydrotreated naphthenic distillates	30 – 60 10 - 30	64742-65-0 64742-52-5	No PEL established No PEL established

Components not listed are not physical or health hazards as defined in 29 CFR 1910.1200 (Hazard Communication Standard).

III. HAZARDS IDENTIFICATION

Medical Conditions Aggravated

by Exposure:

Personnel with pre-existing skin disorders should avoid contact with this

product.

Immediate (Acute) Health Effects by Route of Exposure:

Inhalation Irritation: Inhalation of vapors (generated at high temperatures only) or oil mist may cause mild

irritation of the nose, throat, and respiratory tract.

Skin Contact: Lubricating oils are generally considered no more than minimally irritating to the skin.

May cause skin irritation.

Eye Contact: Lubricating oils are generally considered no more than minimally irritating to the eyes.

May cause slight irritation of the eyes. Can cause irritation.

Ingestion Irritation: Although this product has a low order of acute oral toxicity, aspiration of minute

amounts into the lungs during ingestion or vomiting may cause mild to severe pulmonary

injury and possibly death.

Ingestion Toxicity: Lubricating oils are generally no more than slightly toxic if swallowed.

Long-Term (Chronic) Health Effects:

Carcinogenicity: Not a carcinogen according to NTP, IARC, or OSHA.

Reproductive and

Developmental Toxicity:

No data available to indicate product or any components present at greater than

0.1% may cause birth defects.

Mutagenicity: No data available to indicate product or any components present at greater than

0.1% is mutagenic or genotoxic.

Skin Contact: Prolonged and repeated contact may result in defatting and drying of the skin

that may cause various skin disorders such as dermatitis, folliculitis, or oil acne.

Other adverse effects not expected from brief skin contact.

HMIS Ratings:

Health: 1  Flammability: 1  Reactivity: 0  PPE: B

0 - Least 1 - Slight 2 - Moderate 3 - High 4 - Extreme

IV. FIRST-AID MEASURES

Inhalation: Vapor pressure is very low. Vapor inhalation under ambient conditions is normally not a

problem. If overcome by vapor from hot product, immediately remove from exposure and

call a physician. If breathing is irregular or has stopped, start resuscitation; administer

oxygen, if available. If overexposed to oil mist, remove from exposure until excessive oil

mist condition subsides.

Eyes: Use eye wash to remove a chemical from the eye. Flush the affected eye for at least fifteen

minutes. Tilt the head to prevent chemical from transferring to the uncontaminated eye.

Seek medical attention if irritation persists.

Skin Contact: In case of skin contact, remove any contaminated clothing and wash skin with soap and

water. Launder or dry-clean clothing before reuse. If product is injected into or under the

skin, or into any part of the body, regardless of the appearance of the wound or its size, the

individual should be evaluated immediately by a physician as a surgical emercency. Even

though initial symptoms from high pressure injection may be minimal or absent, early

surgical treatment within the first few hours may significantly reduce the ultimate extent of

injury. Prolonged or repeated skin contact may cause skin irritation.

Ingestion: Minimal risk of harm if swallowed. Do not induce vomiting. Seek medical attention

immediately. Provide medical care provider with this MSDS.No hazard expected under

normal industrial use. If a large quantity is swallowed, seek medical attention. Do not

induce vomiting.

Notes to Doctor: Aspiration during swallowing or vomiting may severely damage the lungs.

V. FIRE FIGHTING MEASURES

Flammability Summary:	Not combustible/ not flammable.
Extinguishing Media:	Use water spray, foam, carbon dioxide, or dry chemical extinguishing agents. Water spray or fog may also be effective for extinguishing if swept across the base of the fire. Water can also be used to absorb heat and keep exposed material from being damaged by fire.
Fire and/or Explosion Hazards:	Material may be ignited only if preheated to temperatures above the high flash point, for example in a fire.
Fire Fighting Methods and Protection:	Do not enter fire area without proper protection including self- contained breathing apparatus and full protective equipment.  Use methods for the surrounding fire.
Hazardous Combustion Products:	Carbon dioxide, Carbon monoxide,

VI. ACCIDENTAL RELEASE MEASURES

Personal Precautions and Equipment:	No adverse health affects expected from the clean-up of  spilled material. Follow personal protective equipment recommendations found in Section VIII of this MSDS.
Methods for Clean-up:	Prevent the spread of any spill to minimize harm to human health and the environment if safe to do so. Wear complete and proper personal protective equipment following the recommendation of Section VIII at a minimum. Dike with suitable absorbent material like granulated clay. Gather and store in a sealed container pending a waste disposal evaluation.

VII. HANDLING AND STORAGE

Handling Technical Measures and Precautions:	No special handling instructions due to toxicity.
Storage Technical Measures and Conditions:	Store in a cool dry ventilated location. Isolate from incompatible materials and conditions. Keep container(s) closed.  Do not expose to extreme temperatures or flames.

VIII. EXPOSURE CONTROLS/PERSONAL PROTECTION

Engineering Measures:

Local exhaust ventilation or other engineering controls may be required when handling or using this product to avoid overexposure.

Respiratory Protection:	Respiratory protection may be required to avoid overexposure when handling this product. General or local exhaust ventilation is the preferred means of protection. Use a respirator if general room ventilation is not available or sufficient to eliminate symptoms.
Respirator Type(s):	None required where adequate ventilation is provided. If airborne concentrations are above the applicable exposure limits, use NIOSH/MSHA approved respiratory protection.
Eye Protection:	Wear safety glasses when handling this product if there is a likelihood of contact with eyes.
Skin Protection:	Where use can result in skin contact, practice good personal hygiene and wear impervious gloves. Wash hands and other exposed areas with mild soap and water before eating, drinking, and when leaving work.
Gloves:	Neoprene

Control Parameters:

Chemical Name	ACGIH TLV-TWA	ACGIH STEL	IDLH
Distillates (petroleum), solvent-dewaxed heavy paraffinic Heavy hydrotreated naphthenic distillates OSHA PEL TWA for oil mist is 5mg/m3, ACGIH TLV TWA for oil mist is 5mg/m3, ACGIH STEL for oil mist is 10mg/m3	No TLV No TLV		ND ND

OSHA PEL TWA for oil mist is 5mg/m3, ACGIH TLV TWA for oil mist is 5mg/m3, ACGIH STEL for oil mist is 10mg/m3

IX. PHYSICAL AND CHEMICAL PROPERTIES

Physical State:	Liquid
Color:	Depends upon product selection
pH:	ND
Solubility in Water:	Insoluble
Specific Gravity:	0.862
Bulk Density:	7.193

X. STABILITY AND REACTIVITY

Stability:	Stable under normal conditions.
Conditions to Avoid:	Temperatures above the high flash point of this combustible material in combination with sparks, open flames, or other sources of ignition.
Materials to Avoid/Chemical Incompatibility:	Strong oxidizing agents
Hazardous Decomposition Products:	Carbon monoxide, sulfur oxides, aldehydes, and other petroleum decomposition products in the case of incomplete combustion.  Oxides of nitrogen, phosphorus, calcium, copper, magnesium, sodium, and hydrogen sulfide may also be present.

XI. TOXICOLOGICAL INFORMATION

Component Toxicology Data (NIOSH):

Chemical Name	CAS Number	LD50/LC50
Petroleum distillates, solvent dewaxed heavy paraffinic Petroleum distillates, hydrotreated heavy naphthenic	64742-65-0 64742-52-5	Inhalation LC50 Rat: 2.18 mg/L/4H; Oral LD50 Rat:>5000 mg/kg; Dermal LD50 Rabbit:>2000 mg/kg Inhalation LC50 Rat: 2.18 mg/L/4H; Oral LD50 Rat:>5000 mg/kg; Dermal LD50 Rabbit:>2000 mg/kg

XII. ECOLOGICAL INFORMATION

Overview:	Moderate ecological hazard. This product may be dangerous to plants and/or wildlife.
Mobility:	No data
Persistence:	No data
Bioaccumulation:	No data
Degradability:	No data
Ecological Toxicity Data:	0

XIII. DISPOSAL CONSIDERATIONS

Disposal of Packaging:	Recycle containers whenever possible.
Disposal Methods:	Dispose of according to Federal, State, Local, or Provincial regulations.  Recycle used oil.

XIV. TRANSPORTATION INFORMATION

DOT & IMDG:  NOT RESTRICTED

XV. REGULATORY INFORMATION

TSCA Status:

A component or components of this product are listed on the TSCA Inventory of Existing Chemical Substances.

Chemical Name	CAS #	Regulation	% Range
No 313-listed chemicals above threshold		SARA 313

XVI. ADDITIONAL INFORMATION

Disclaimer:

This material safety data sheet and the information it contains is offered to you in good faith as accurate.  We have reviewed any information contained in the data sheet which we have received from outside sources and we believe the information to be correct, but cannot guarantee its accuracy or completeness.  Health and safety precautions in this data sheet may not be adequate for all individuals and/or situations.  It is the user's obligation to evaluate and use this product in a safe manner and to comply with all applicable laws and regulations.  No statement made in this data sheet shall be construed as permission or recommendation for the use of any product in a manner that might infringe existing patents.  No warranty is made, either expressed or implied.